When installing a 2 post car lift on a concrete floor, it is important to consider the slope of the floor and the thickness of the concrete. You must also consider the mechanical locking mechanisms view website for learning. These features will make the installation easier and ensure that the car lift stays stable even when the lift is raised.
Installation of 2 post car lift on concrete floor
Before installing a 2 post car lift, it is important to measure the concrete thickness. The thickness should be at least four inches, depending on the type of concrete and its strength. In addition, the floor must be level and not sloped. You can check the concrete thickness by drilling a hole and measuring the PSI. Next, lay out the lift.
To install a two-post car lift on a concrete floor, you must make holes that are at least 4.25" deep and 12 inches wide. After that, you need to pour concrete into the holes. It is important to follow the manufacturer's specifications.
Slope of floor
When installing a 2 post car lift, you need to account for the slope of the floor. Some lifts require a perfectly flat floor and others require a slope of 1 degree or less. Fortunately, you can make the floor slope less significant by shimming the lower post.
The slope of the floor should be no more than one inch over eight feet. If the floor is more than that, consider using shim plates to raise the low-side column above the floor. This will ensure that both lift pads are at the same height.
Mechanical locking mechanisms
Mechanical locking mechanisms for a 2 post car lift must be robust enough to prevent accidental movement. The mechanism must engage locks every 100mm, and the carriage must be synchronised. The carriages should also be fitted with safety catches to prevent them from falling out while the lift is in use.
Mechanical locking mechanisms for a 2-post car lift are typically ratchet-type devices. A ratchet pawl connects to a ratchet track on the lift carriage, and a spring biases the pawl into the engaged position. These devices prevent the carriage from moving down accidentally if the cable breaks.
Cost
If you're planning on installing a 2-post car lift in your garage, you'll need to determine the exact cost of the installation. You'll need to take into account the size of your shop, how much space you have available, and the type of concrete slab you have. Once you've established this, you can proceed with the rest of the installation.
In addition to determining the price, you'll need to consider the type of lift you'd like to buy. Some lifts may not require any electrical work, while others require an air compressor. Also, before making a purchase, double check the dimensions, including ceiling clearance and the height of your vehicle once it's elevated. Using a normal-sized car, you'll be able to test the height of your lift and compare it with the maximum height your garage can accommodate. Also, remember to allow for mistakes in measurements and err on the side of caution.
Size of lift
When you're considering purchasing a car lift, there are many factors to consider. First, the amount of space you'll need between the lift and the bay door is crucial. The recommended distance between the lift and the bay door is about 13 feet. This distance will allow for your customers to drive in and out of your shop without the car sticking out the back door.
If you don't have a lot of space, you can choose a portable two post car lift. This lift is light and compact, but can hold 7,000 pounds. It's made of premium materials and comes with adjustable width up to 120 inches at the center of the column.